Cozoy Takt Pro

• COZOY TAKT Pro decoders use the same aviation aluminum alloy AL6063 of the several generations iPhone to build. Equipped with high-performance decoder chip and line design, coupled with the chip built-in DSP (Digital Sound Processing) digital correction engine settings, in order to bring strong output drive, very low noise and ultra-high signal-to-noise ratio under a very small volume, which compared with the traditional decoding amplification combination, non-general meticulous sound experience
• Each set of TAKT pro includes Lighting (including genuine Apple transmission chip), USB and Micro USB OTG wire, support iOS, Android and a variety of USB platform. TakT Pro has a signal-to-noise ratio of up to 120dB and a low delay of 80ms, install the ASIO Driver, then compatible with a variety of DAW and fine tuning.

Use the special customized SABRE9018Q2C for portable devices

• TAKT PRO uses the SABRE9018Q2C reference level D / A converter, the chip uses advanced 40-QFN package, built-in Time Domain Jitter Eliminator technology. The 32-Bit HyperStream architecture native supports 32-bit 384kHz PCM signals and up to DSD-11.2MHz signal processing.

Without battery, screw design and coupled with the top parameters

• Through the USB device to take power (without battery aging risk)
• 6063 aluminum alloy to create a smooth shell (aluminum, magnesium, silicon mixed materials, reduce the bad resonance)

Support ADIO (80ms low latency)

• 32Bit 384 kHz (recording engineer level file decoding)
• Native decoding playback, DSD 256-11, 289, 600 (11.2MHz)

Emphasize material, focus on the stability of the streamlined design

• Ultra-lightweight design, suitable for daily carry

Integral and without screws, can be detachable cable design

• Very low ripple linear power supply

Asynchronous clock

• Six independent regulator circuits
• Connect with your portable device

Each TAKT Pro contains three wires:

• Micro-micro USB cable – Android phones, tablets
• full size USB cable – MACs, Laptops, PC systems